Önskemål om en handledning till mina rosenknoppar har inkommit till mig så här kommer den!
Jag använder den här stansen från Sizzix, Tattered floral ( Tim Holtz) till de här här rosenknopparna. Perfekt för de små restbitarna av card stock, billigare än att köpa och snyggare!
****
I have been requested to make a Tutorial on my rose buds, so here it comes!
I use this punch from Sizzix, Tattered floral (Tim Holtz) to make this rose-buds. Perfect forall the small scraps of cardstock, cheaper than buying and better looking!
- Utstansad blomma
- Grön Ståltråd
- Liten kvadrat av Mullbärs papper eller annat mjukt grönt papper
- Florist tejp
- Lim
****
- Punched flower
- Green Wire
- Small squares of mulberry paper or other soft green paper
- Florist tape
- Glue
För att ge blombladen lite textur använder jag en stylus och samtidigt mjukas card stocken upp.
To give the petals some texture, I use a stylus and simultaneously get the card stock softer.
Klipp bort mitten…
Cut out the middle …
Jag böjer varje blomblad med hjälp av ett grillspett, det är enklare att montera samman…tycker jag!
I bend each pedels beore I mount the bud, it is easy put it together … I think!
Första blombladet aplicerar jag lim på hela bladet, de andra enligt markeringen.
On the first petal I aplicerar glue on the whole pedal and the other on the marks.
Lägg ståltråden i ena kanten på det första blombladet och snurra papperet runt det tajt.
Place the wire at one edge of the first petal and turn the paper around it tight.
Lägg skarven mitt på nästa blomblad…och så vidare tills alla blombladen är monterade runt ståltråden.
Place seam in the middle of next petal … and so on until all the petals are mounted around the wire.
Alla blombladen monterade!
All petals mounted!
Klipp från hörn till hörn ett V, slut resultatet skall se ut så här, att de är ojämna gör ingenting, de ser me naturliga ut om de är ojämna tycker jag i alla fall.
Cut from corner to corner a V, the end result should look like this,that they are uneven doesn’t do anything, they look more natural if they are uneven, I think, anyway.
Aplicera och limma fast mot rosenknoppen.
Aplicera and glue the rose-bud.
Dela florist tejpen på mitten
Cut the florist tape to the middle
Applicera lim på ståltråden och starta tvina tejpen på ståltråden och skjut den upp över limmet. Jag limmar för att vara säkert på att tejpen inte skall tvinnas upp.
Apply glue to the wire and start twintape on the wire and slide it up over the glue. I glue to be sure that the tape is not twisted up.
Applicera tejpen något diagonalt och omlott.
Apply the tape slightly diagonally and overlapped.
Limma sista biten av samma anledning som starten
Glue the last bit of the tape of the same reason as the start.
Till sist använd en pincett för att böja till blombladen, för att skapa mer liv till resenknoppen.
Finally, use a tweezers to bend the petals, to create more life to the rosebud.
Här är slutresultat!
Here are the final result!
Lämna ett svar